2 layer board of 1.69 x 1.39 inches (42.9 x 35.3 mm)
Uploaded:
February 23rd 2022
Shared:
February 23rd 2022
Total Price:
$11.70
Breakout to allow MCP2515 to interface with low speed (<125kbps) CAN using the TJA1054 transceiver
Needs a compatible 8mhz crystal (see TJA1054 datasheet) and various 0805 capacitors and resistors, along with the two IC's. Headers for CAN bus via a screw terminal (3.5mm pitch) or two pin wire j…
Breakout to allow MCP2515 to interface with low speed (<125kbps) CAN using the TJA1054 transceiver
Needs a compatible 8mhz crystal (see TJA1054 datasheet) and various 0805 capacitors and resistors, along with the two IC’s. Headers for CAN bus via a screw terminal (3.5mm pitch) or two pin wire jumper (0.1" pitch). Optional terminator jumper for ~120ohm terminator resistor.
Not tested but based on a breakboarded design - should work.
Show full description
Breakout to allow MCP2515 to interface with low speed (<125kbps) CAN using the TJA1054 transceiver
Needs a compatible 8mhz crystal (see TJA1054 datasheet) and various 0805 capacitors and resistors, along with the two IC's. Headers for CAN bus via a screw terminal (3.5mm pitch) or two pin wire j…
Breakout to allow MCP2515 to interface with low speed (<125kbps) CAN using the TJA1054 transceiver
Needs a compatible 8mhz crystal (see TJA1054 datasheet) and various 0805 capacitors and resistors, along with the two IC’s. Headers for CAN bus via a screw terminal (3.5mm pitch) or two pin wire jumper (0.1" pitch). Optional terminator jumper for ~120ohm terminator resistor.
Not tested but based on a breakboarded design - should work.
Show full description