Shared projects

TFT display Shield for UNO.

By Firebirduino

2 layer board of 2.02 x 0.61 inches (51.4 x 15.5 mm).
Shared on August 9th, 2016 06:29


TFT display Shield for UNO.

By Firebirduino

2 layer board of 2.02 x 0.61 inches (51.4 x 15.5 mm).
Shared on August 9th, 2016 06:29

A small Shield for the popular 2.2" TFT display. Only needs 3 through hole parts, 74HC4050N, 100 ohm resistor and 0.1uf cap, plus connectors. Arduino control signals: D9->D/C, D10->CS. Fully tested.

See the product at www.firebirduino.com



STM32 F4 Stamp Mini Breakout

By Firebirduino

2 layer board of 1.61 x 1.01 inches (40.8 x 25.6 mm).
Shared on June 23rd, 2016 04:28


STM32 F4 Stamp Mini Breakout

By Firebirduino

2 layer board of 1.61 x 1.01 inches (40.8 x 25.6 mm).
Shared on June 23rd, 2016 04:28

A new STM32F405RGT mini F4stamp is based on Frank Zhao’s design for DIY makers.

More details and schematic available at www.firebirduino.com



UU - MIND+ with STM32 F103CBU6

By Firebirduino

2 layer board of 1.82 x 0.44 inches (46.1 x 11.2 mm).
Shared on May 1st, 2016 23:38


UU - MIND+ with STM32 F103CBU6

By Firebirduino

2 layer board of 1.82 x 0.44 inches (46.1 x 11.2 mm).
Shared on May 1st, 2016 23:38

DIY UNO Upgrade with the STM32F103CBU6, 72 MHz STM32, Cortex M3, fastest ARM controller in the UNO form factor.

ATMEGA328P DIP drop-in replacement.

Schematic and BOM available at www.firebirduino.com



UU - MIND with STM32

By Firebirduino

2 layer board of 1.82 x 0.43 inches (46.1 x 10.8 mm).
Shared on April 9th, 2016 23:42


UU - MIND with STM32

By Firebirduino

2 layer board of 1.82 x 0.43 inches (46.1 x 10.8 mm).
Shared on April 9th, 2016 23:42

DIY UNO Upgrade with the STM32F103TBU6,
72 MHz STM32, Cortex M3, fastest ARM controller in the UNO form factor.

ATMEGA328P DIP drop-in replacement.

Schematic and BOM available at www.firebirduino.com



Arduino ZERO JR-V2

By Firebirduino

2 layer board of 2.72 x 2.11 inches (69.0 x 53.6 mm).
Shared on December 18th, 2015 03:15


Arduino ZERO JR-V2

By Firebirduino

2 layer board of 2.72 x 2.11 inches (69.0 x 53.6 mm).
Shared on December 18th, 2015 03:15

Arduino Zero compatible board based on the AtsamD21G18A for DIY.

www.firebirduino.com